Not sure if anyone else here has these speakers, but here are the official torque settings for the record, just in case:
Tweeter is 0.6Nm
Midrange is 0.75Nm
Woofer is 0.75Nm
These were provided by Peter Thomas on the FB PMC group.
PMC Torque Settings
Moderator: Staff
-
sunbeamgls
- Very active member
- Posts: 1116
- Joined: 2012-04-04 15:19
- Location: North Wales
- Contact:
PMC Torque Settings
KSH/0; KEBox/2; 3x Tundra Stereo 2.5; PMC fact.12. Blogger. Exakt Design. SO measuring.
-
sunbeamgls
- Very active member
- Posts: 1116
- Joined: 2012-04-04 15:19
- Location: North Wales
- Contact:
Re: PMC Torque Settings
Following PMC's input to a discussion on torque settings for Twenty.26 on an unofficial Facebook group, they've pro-actively published torque settings for all their speakers on their FAQ pages.
I think they should be congratulated on this approach.
https://pmc-speakers.com/faq-page
I think they should be congratulated on this approach.
https://pmc-speakers.com/faq-page
KSH/0; KEBox/2; 3x Tundra Stereo 2.5; PMC fact.12. Blogger. Exakt Design. SO measuring.
Re: PMC Torque Settings
That’s commendable for them to go to this detail to get the best results for the hard earned cash.