I have just installed a new trampolin 2 and noticed how close the p-clip (new type) is to the baseboard. If it is touching what impact is that likely to have on SQ?
If there is a problem the only thing I cam think of doing is moving the motor earth from the rear bolt to the the front one. Is that viable?
Thanks for your help
Mike
P-Clip touching trampolin
Moderator: Staff
Re: P-Clip touching trampolin
As long as they are not touching each other when you play a heavy record I think you are ok. If they touch I would take it to an experienced LP12 dealer for service.
It’s that live feeling…………….
Re: P-Clip touching trampolin
If I understand your question correctly, Mikeg, then beck must have misunderstood it.
The P-clip holding the arm cable should not touch the baseboard. Indeed it's much bigger than the old ones, but I've never had any of them touching the baseboard. If so, I would expect there's too many nuts or washers above it (should be one big washer and one nut, then the P-clip.
Motor earth? What is that and where does it fit?
Maybe I have misunderstood you after all. Posting a picture will help!
The P-clip holding the arm cable should not touch the baseboard. Indeed it's much bigger than the old ones, but I've never had any of them touching the baseboard. If so, I would expect there's too many nuts or washers above it (should be one big washer and one nut, then the P-clip.
Motor earth? What is that and where does it fit?
Maybe I have misunderstood you after all. Posting a picture will help!