Torque Radikal

minge · Post by **minge** » 2012-03-29 06:14

Does anybody know the right torque for the 14 screws inside the Radikal?

Mike

Tony Tune-age · Post by **Tony Tune-age** » 2012-03-29 15:16

minge wrote:Does anybody know the right torque for the 14 screws inside the Radikal?

ThomasOK has the exact torque settings for all fourteen screws, and there is a post on this forum which contains this information.

minge · Post by **minge** » 2012-03-29 17:21

Tony Tune-age wrote:
minge wrote:Does anybody know the right torque for the 14 screws inside the Radikal?
ThomasOK has the exact torque settings for all fourteen screws, and there is a post on this forum which contains this information.

I hae searched but cant fint the thread anybody ho can help?
Mike

Tony Tune-age · Post by **Tony Tune-age** » 2012-03-29 19:00

minge wrote:
Tony Tune-age wrote:
minge wrote:Does anybody know the right torque for the 14 screws inside the Radikal?
ThomasOK has the exact torque settings for all fourteen screws, and there is a post on this forum which contains this information.
I hae searched but cant fint the thread anybody ho can help?

I thought it was listed in the Hi-Fi section, under Radikal, but could not find the torque topic. I'll have to conduct a more detailed search. But if you sent ThomasOK a message, he might be able to provide the actual specifications.

Charlie1 · Post by **Charlie1** » 2012-03-29 19:52

I think Thomas posted this on the Linn forum, not here, but I have a record of approximately 0.4Nm for both the circuit board and dynamik. I would start off there and fine tune by ear.

ThomasOK · Post by **ThomasOK** » 2012-03-29 22:50

Mike has PMed me and I sent him the information. Charlie1 is correct on the starting point for the circuit boards - my finding was extremely close to the .4Nm mark.

minge · Post by **minge** » 2012-03-30 05:53

ThomasOK wrote:Mike has PMed me and I sent him the information. Charlie1 is correct on the starting point for the circuit boards - my finding was extremely close to the .4Nm mark.

Thanks everybody for the information on the Radikal.

Mike

Tony Tune-age · Post by **Tony Tune-age** » 2012-03-30 14:54

minge wrote:
ThomasOK wrote:Mike has PMed me and I sent him the information. Charlie1 is correct on the starting point for the circuit boards - my finding was extremely close to the .4Nm mark.
Thanks everybody form the information on the Radikal.

Glad you got the information, good luck!

Torque Radikal

Torque Radikal

Re: Torque Radikal

Re: Torque Radikal

Re: Torque Radikal