Tundra Mono’s - Trim meter

Hardware and software, modifications and DIY

Moderator: Staff

Post Reply
William
Member
Member
Posts: 21
Joined: 2016-07-19 16:52
Location: Glasgow

Tundra Mono’s - Trim meter

Post by William »

Hi,

I’ve been stupid enough to leave the meter on and now the batter has died.

Any advice on changing the battery and does changing the battery impact the calibration value (I would expect not)?

Thanks,

William
User avatar
lejonklou
Administrator
Administrator
Posts: 6524
Joined: 2007-01-30 10:38
Location: Sweden
Contact:

Re: Tundra Mono’s - Trim meter

Post by lejonklou »

Hi William!

No worries. It's a standard 9V battery (called 6LR61, 6LF22 or PP3) and to replace it you remove two screws on the rear side of the instrument.

You need a thin screwdriver (with a small Phillips tip) because the screws are recessed into holes in the orange plastic.

The battery change doesn't affect the calibration of the instrument.
William
Member
Member
Posts: 21
Joined: 2016-07-19 16:52
Location: Glasgow

Re: Tundra Mono’s - Trim meter

Post by William »

Thanks Fredrik.

Best regards,

William
Post Reply