ADSM/1 torque recommendations
Moderator: Staff
- Tendaberry
- Very active member
- Posts: 987
- Joined: 2010-08-30 16:08
- Location: Hamburg
ADSM/1 torque recommendations
Does anyone have torque recommendations for the ADSM/1? I assume they are different from the values for the KDS and KDSM.
Re: ADSM/1 torque recommendations
Resurrecting this thread
Which are the optimal torque settings for Akurate Radikal?
M.
Which are the optimal torque settings for Akurate Radikal?
M.
Re: ADSM/1 torque recommendations
I seem to recall it's around 0.4Nm but can't find reference to it. Doesn't help that the Linn forum is no more as Tom put quite a few on there as well as here. You should really fine tune by ear anyway, so perhaps just start at that figure.
EDIT: Found this via Google...
The Dynamiked Radikal - Linn Forums
forum.linn.co.uk/bb/showthread.php?tid=10583&page=22
17 May 2011 - 10 posts - 6 authors
The T10 of the case were above 0.6 Nm, the PCB PH1 were below 0.4 Nm. Setting them to to the mentioned values resulted in a worse sound.
EDIT: Found this via Google...
The Dynamiked Radikal - Linn Forums
forum.linn.co.uk/bb/showthread.php?tid=10583&page=22
17 May 2011 - 10 posts - 6 authors
The T10 of the case were above 0.6 Nm, the PCB PH1 were below 0.4 Nm. Setting them to to the mentioned values resulted in a worse sound.
Re: ADSM/1 torque recommendations
Thanks
How can you read the thread?
M.
How can you read the thread?
M.
Re: ADSM/1 torque recommendations
It just came up in the Google search where it includes a snippet of text.
Re: ADSM/1 torque recommendations
Does it means that the better values are case 0.6 Nm and PCB 0.4?Charlie1 wrote: ↑2019-01-16 12:18 I seem to recall it's around 0.4Nm but can't find reference to it. Doesn't help that the Linn forum is no more as Tom put quite a few on there as well as here. You should really fine tune by ear anyway, so perhaps just start at that figure.
EDIT: Found this via Google...
The Dynamiked Radikal - Linn Forums
forum.linn.co.uk/bb/showthread.php?tid=10583&page=22
17 May 2011 - 10 posts - 6 authors
The T10 of the case were above 0.6 Nm, the PCB PH1 were below 0.4 Nm. Setting them to to the mentioned values resulted in a worse sound.
M
Re: ADSM/1 torque recommendations
Not really sure - perhaps PM Thomas.