ADSM/1 torque recommendations

[Tendaberry]

Does anyone have torque recommendations for the ADSM/1? I assume they are different from the values for the KDS and KDSM.

[Matteo]

Resurrecting this thread

Which are the optimal torque settings for Akurate Radikal?

M.

[Charlie1]

I seem to recall it's around 0.4Nm but can't find reference to it. Doesn't help that the Linn forum is no more as Tom put quite a few on there as well as here. You should really fine tune by ear anyway, so perhaps just start at that figure.

EDIT: Found this via Google...

The Dynamiked Radikal - Linn Forums
forum.linn.co.uk/bb/showthread.php?tid=10583&page=22
17 May 2011 - 10 posts - ‎6 authors
The T10 of the case were above 0.6 Nm, the PCB PH1 were below 0.4 Nm. Setting them to to the mentioned values resulted in a worse sound.

[Matteo]

Thanks

How can you read the thread?

M.

[Charlie1]

It just came up in the Google search where it includes a snippet of text.

[Matteo]

I seem to recall it's around 0.4Nm but can't find reference to it. Doesn't help that the Linn forum is no more as Tom put quite a few on there as well as here. You should really fine tune by ear anyway, so perhaps just start at that figure.

EDIT: Found this via Google...

The Dynamiked Radikal - Linn Forums
forum.linn.co.uk/bb/showthread.php?tid=10583&page=22
17 May 2011 - 10 posts - ‎6 authors
The T10 of the case were above 0.6 Nm, the PCB PH1 were below 0.4 Nm. Setting them to to the mentioned values resulted in a worse sound.

Does it means that the better values are case 0.6 Nm and PCB 0.4?

M

[Charlie1]

Not really sure - perhaps PM Thomas.