Hello all,
Had my system running 24/7 to run in new dynamic power supply on my unidisk 1.1. Had a new dynamik in my KK1 as well but it was faulty so put the old supply in while waiting for new supply--when the dynamik was first fitted in KK dealer and I noticed a burnt spot and leakage (from a cap maybe) on the old power supply--well the old power supply went while I was running in dynamik on unidisk---my question is when the power supply went out could it possibly damage any other equipment ie. speakers (Klimax 350a)---wont be able to tell until the KK is fitted with new dynamik. Thanks for your input guys!!!
Ron
blown power supply
Moderator: Staff
-
- Member
- Posts: 44
- Joined: 2008-01-07 20:34
- Location: London ontario canada
blown power supply
Ron C.
dynamik
This burn spot is a common phenomenom, it is caused by a regulator running hot, it was cured by having a heat sink fitted on later PSU.
This has to date never caused any problems.
Your 350s should be O.K. unless they suffered a high powered loud surge, I would bet they will be fine.
This has to date never caused any problems.
Your 350s should be O.K. unless they suffered a high powered loud surge, I would bet they will be fine.
-
- Member
- Posts: 44
- Joined: 2008-01-07 20:34
- Location: London ontario canada
-
- Member
- Posts: 44
- Joined: 2008-01-07 20:34
- Location: London ontario canada
- Music Lover
- Very active member
- Posts: 1673
- Joined: 2007-01-31 20:35
- Location: In front of Lejonklou/JBL/Ofil