I bought Urika on Ebay, I found that Urika comes into contact with the Keel, I installed around the trampolin thin aluminum soles of 40x9mm and 30x9mm 2.5mm thick, now the bounce of the springs is fine, My Linn frame is 64mm, the soles raise the frame to 66.5mm,
My lp12 now plays very well with Urika! I was still surprised by this anomaly, my frame Linn is from 2014, Someone may have also encountered this problem with Urika and Keel?
Thank you,
Keel bounce on Urika case
Moderator: Staff
Re: Keel bounce on Urika case
You can read about it here:
https://www.lejonklou.com/forum/viewtop ... it=Radikal
Edit:
Welcome to the forum :)
https://www.lejonklou.com/forum/viewtop ... it=Radikal
Edit:
Welcome to the forum :)
Re: Keel bounce on Urika case
Since that thread is about the Radikal motor touching one of the Trampolin's feet, I'm less convinced it is the same issue.maffe wrote: ↑2019-11-01 17:55 You can read about it here:
https://www.lejonklou.com/forum/viewtop ... it=Radikal
Re: Keel bounce on Urika case
Thank you for your answers,
Yes the Urika/Keel problem is not the same as the Radikal Engine/Trampolin Foot Membrane, However the 2 problems are the cause of a LP12 wooden frame with insufficient height, My wood frame 64mm minus 4mm(60mm) for fixing the trampolin, Urika rested on the Keel,
Sorry about the communication I use a language translator,
Yes the Urika/Keel problem is not the same as the Radikal Engine/Trampolin Foot Membrane, However the 2 problems are the cause of a LP12 wooden frame with insufficient height, My wood frame 64mm minus 4mm(60mm) for fixing the trampolin, Urika rested on the Keel,
Sorry about the communication I use a language translator,