Using Torque Screwdriver on LP12

We use the Tune Method to evaluate performance

Moderator: Staff

Freddy
Active Member
Active Member
Posts: 84
Joined: 2012-07-05 21:55
Location: Sweden

Re: Using Torque Screwdriver on LP12

Post by Freddy »

Have now tested a few torques at the arm collar screw. It was the easiest to start with. Started at 1.5 Nm and then increased to 1.6, 1.65, 1.7, 1.8 Nm. Very close between 1.6 and 1.65 then the rest was clearly worse. The driver makes an audible click at the selected torque value. I made two clicks at the selected torque value, is that the way to do it? Seems quite easy to use now when I understand how it works.
Last edited by Freddy on 2020-11-30 14:00, edited 2 times in total.
Defender
Very active member
Very active member
Posts: 1266
Joined: 2018-02-14 22:35

Re: Using Torque Screwdriver on LP12

Post by Defender »

are you sure about 0.6Nm? all agree its rather 1.6 +1notch - I let it click for 2-3times
Freddy
Active Member
Active Member
Posts: 84
Joined: 2012-07-05 21:55
Location: Sweden

Re: Using Torque Screwdriver on LP12

Post by Freddy »

Defender wrote: 2020-11-29 18:43 are you sure about 0.6Nm? all agree its rather 1.6 +1notch - I let it click for 2-3times
You´re right, it´s a typo! I was looking on the scale on the driver but forgot that it´s a 1 also to be added. Sorry I should have written 1.6... . I change that in the post above so no confusion starts.
Post Reply