End of side distortion
Posted: 2014-03-18 14:59
Hi
I am experiencing end of side distortion on some albums. I am after some advice on how to reduce/eliminate it. I have become aware of more recently so it may be down to recent changes in my system.
My system is LP12, kore, ittok, Adikt, Avondale TAPS, Naim 72/HiCap/250, SBL’s.
Settings:
Adikt to Headshell 0.266Nm
VTF 1.7g (per Ittok) 1.748g per Roksan electronic gauge
Bias 1.9
Arm pillar (raised slightly-1.5mm) 2.6Nm
Adikt lugs have been removed and alignment is correct via a Linn protractor
I have checked the bearings using the info from a post by ThomasOK. Passes the vertical test easily with a small 25mm sq pice of paper. Horizontal - 0.25 bias – smoothly swings accros the rsurface iof the record, 0.4 – swings back to it’s rest.
I have made some changes to the system recently which may have Highlighted the problem:
New tweeters to replace aging 26year olds
Kore, plinth and SS topplate
Recent service to 72/HiCap
I have also recently started using Lyra’s SPT fluid and that is when I started to be particularly aware of the problem. At the start of the record the music was clear and clean but on the final track it sounded like a dirty stylus mistracking. Cleaning with green paper reduced but did not eliminate the problem. I have stopped using it partly for this reason but also because I am not convinced that musically it is better than green paper with silly putty.
The Adikt has probably less than 500 hours use so I don’t think it is due to be replaced.
Any advice would be most welcome
Mike
I am experiencing end of side distortion on some albums. I am after some advice on how to reduce/eliminate it. I have become aware of more recently so it may be down to recent changes in my system.
My system is LP12, kore, ittok, Adikt, Avondale TAPS, Naim 72/HiCap/250, SBL’s.
Settings:
Adikt to Headshell 0.266Nm
VTF 1.7g (per Ittok) 1.748g per Roksan electronic gauge
Bias 1.9
Arm pillar (raised slightly-1.5mm) 2.6Nm
Adikt lugs have been removed and alignment is correct via a Linn protractor
I have checked the bearings using the info from a post by ThomasOK. Passes the vertical test easily with a small 25mm sq pice of paper. Horizontal - 0.25 bias – smoothly swings accros the rsurface iof the record, 0.4 – swings back to it’s rest.
I have made some changes to the system recently which may have Highlighted the problem:
New tweeters to replace aging 26year olds
Kore, plinth and SS topplate
Recent service to 72/HiCap
I have also recently started using Lyra’s SPT fluid and that is when I started to be particularly aware of the problem. At the start of the record the music was clear and clean but on the final track it sounded like a dirty stylus mistracking. Cleaning with green paper reduced but did not eliminate the problem. I have stopped using it partly for this reason but also because I am not convinced that musically it is better than green paper with silly putty.
The Adikt has probably less than 500 hours use so I don’t think it is due to be replaced.
Any advice would be most welcome
Mike