I need a set of instructions (a photo step by step would be great) on how to remove a set of active cards from a late model klout and turn it passive again. Apparently it is quite easy however I want to ensure I do it correctly. Can someone email me instructions or post them here so I can save them...
[email protected]
Klouts active to passive
Moderator: Staff
Re: Klouts active to passive
Open case, 2 screws.
Unplug and remove both cards completely.
Re-solder the cut loop-link together both sides.
Close up case, you're done.
Unplug and remove both cards completely.
Re-solder the cut loop-link together both sides.
Close up case, you're done.
Rega NAIA, Aphelion II, Aura. Naim CB 32.5/HC, Naxo 3-6/HC, 3x250 into K20/DMS.
Re: Klouts active to passive
Check your mailbox Dave. :-)
Re: Klouts active to passive
Hi ITB I have Aktiv Klouts ,I'm wondering if you have a more explicit instruction that you could share here please
I know that tune
- El Mero Mero
- Active member
- Posts: 107
- Joined: 2007-11-04 22:38
- Location: Sweden
Re: Klouts active to passive
I have a Klout Service Manual in PDF form. Send me a PM with your email adress and I will send it to you.
Sorry, Just checked the Manual. No description of how its done. But there are two cut links, one for each aktiv card that needs to be resoldered to make the amps passive again.
Sorry, Just checked the Manual. No description of how its done. But there are two cut links, one for each aktiv card that needs to be resoldered to make the amps passive again.
Re: Klouts active to passive
Link is LK1 on Klout Board.
You do not have the required permissions to view the files attached to this post.