ITB wrote: ↑2021-01-26 18:49 I have made the recordings with Songcorder and listen to the tracks during recording, KK at low volume.

Thanks ITB,

Those are very good recordings, I also use low or zero volume, for best results, when recording vinyl to digital.

..recordings I've made in summer 2018 comparing the same Radikal board and Dynamik PSU in Akurate and Klimax housing. I like to share these recordings so you can hear the difference by yourself, or not :-) Thanks ITB. For me, that closes the issue pretty conclusively. By the way, was the sound play...

We even makeshift mounted the Karousel bearing into the pre-Cirkus subchassis It seems the Karousel bearing is designed more for aluminium sub chasis. For me, Karousel bearing with Kore is an improvement on the previous Cirkus bearing. But I have kept my Cirkus bearing in case Karousel deteriorates...

I'm afraid that's the only way it will work with a Trampolin and it's OK. The back of the LP12 is heavier than the front, and with an Ekos SE it is especially heavy on the right back. This will cause the LP12 to sit a bit lower at the back and sometimes lower yet on the back right. On my LP12s I do...

Unfortunately the 3.4 clips still have some of that staccato one-note bass and detail-orientedness that I hear on Karousel decks live. It's as if every note and every sound starts and stops abruptly, giving a false impression of "clarity" while ruining the nuances of the interplay. My Cirkus deck d...

There is also a torque for the bottom cap and that is much lower. I found that I had to go above 2.0Nm to loosen it and 2.4Nm was where it loosened up on my driver. Testing some torques near that I found that 2.4Nm +2 notches was most musical. I would be careful with this cap and only just barely l...