Linn Axis Speed
Posted: 2023-03-16 21:13
Thanks to the helpful tips on John's thread here viewtopic.php?f=3&t=6182
I cleaned my motor pulley, tho it was only very lightly soiled.
I then checked the speed using a phone app.
It was averaging 32.40 rpm, so adjusted the two screws on the underside and eventually settled on this result:
I started by turning both screws to their extremities to check the resulting speeds.
At max anticlockwise the speed seemed highest, so I started with the screw closest to the centre and turned it incrementally clockwise until I got close to 33.3, then gradually adjusted the other until I got as close as I could to 33.33 on average.
Is this the right technique, does anyone know?
Are my results typical for an Axis? There seems to be a lot of speed variation. I noticed that the results were very sensitive to the location of the phone, so I tried to ensure it was central.
I cleaned my motor pulley, tho it was only very lightly soiled.
I then checked the speed using a phone app.
It was averaging 32.40 rpm, so adjusted the two screws on the underside and eventually settled on this result:
I started by turning both screws to their extremities to check the resulting speeds.
At max anticlockwise the speed seemed highest, so I started with the screw closest to the centre and turned it incrementally clockwise until I got close to 33.3, then gradually adjusted the other until I got as close as I could to 33.33 on average.
Is this the right technique, does anyone know?
Are my results typical for an Axis? There seems to be a lot of speed variation. I noticed that the results were very sensitive to the location of the phone, so I tried to ensure it was central.